免费发布信息
ELECTRICal signal, and then extract and output the clock of the ELECTRICal signal. Clock signal is mainly used for the trigger signal of oscilloscope. UC9710A CDR（时钟恢复仪）主要用于在没有触发时钟的测试环境，提供时钟恢复信号，从而利用采样示波器测试器件的光眼图。典型应用是光网络设备的测试，或者针对PON应...
Absolute maximum ratings:parameter symbol value unitOperating temperature Top -20～+85 ℃Storage temperature Tstg -40～+100 ℃Laser diode Reverse voltage Vr 2 VSoldering temperature/time 260/10 ℃/SELECTRICal and optical characteristics:(T=25℃)parameter symbol Min. Typ. Max. unitCenter wavelength λ 1640 165...
ELECTRIC cooler voltage VTEC 2.6 V Forward current 5 mA Reverse current 2 mA Lead solder Temperature -- 260 °C -- Lead Soldering Time -- 10 s -- Optical/ELECTRICal Characteristics (T=25℃，unless otherwise...
ELECTRICal characteristics Parameter Symbol Min. Typ. Max. Unit Test condition Detection range λ 1530 1550 1570 nm - Dark current Id - 1 5 nA VR=5V，25°C Quantum efficiency R 0.80 - - A/W ...
ELECTRIC) controller modules with up to 32 W of power and voltage measurement, and controller modules with laser control from 200 mA to 2 A and integrated 12 W TE control.FeaturesWide Range of ModulesFour current source modules and five combination modules along with two TE controller only modules make the LD...
TheModel 3150 Temperature Controllerprovides a 350 W bipolar output for operation with thermoELECTRIC (TE) coolers. Active power management of the output DC power supply reduces unnecessary power dissipation resulting in increased temperature stability and higher reliability. Full 16-bit control and character...
ELECTRIC) controller modules with up to 32 W of power and voltage measurement, and controller modules with laser control from 200 mA to 2 A and integrated 12 W TE control.FeaturesWide Range of ModulesFour current source modules and five combination modules along with two TE controller only modules make the LD...
ELECTRICians know that when you are measuring ELECTRICal installations there often appears to be a voltage, even if you know the wires are non energized. This is called stray or ghost voltages and is caused by the capacity between wires. Because of the very high impedance input of the meter, this stray voltag...
The Agilent 54121A oscilloscope is a graph-displaying device – it draws a graph of an ELECTRICal signal. In most applications, the graph shows how signals change over time: the vertical (Y) axis represents voltage and the horizontal (X) axis represents time. The intensity or brightness of the display is some...
ELECTRICity driving 电子驱动 Non-latching非锁定 Pin1 Pin10 V+ GND GND V+ State 状态 Non-latching非锁定 Pin2-3, Pin8-9 open Pin2-3, Pin8-9 close Pin3-4, Pin7-8 close Pin3-4, Pin7-8 open 型号B ...
|